Li-Po Gens Ace 1000 mAh 25C Nunchuck 7.4V T-Deans battery (shortened cable)

Li-Po Gens Ace 1000 mAh 25C Nunchuck 7.4V T-Deans battery (shortened cable)

The battery has been specifically designed to power airsoft guns. It is suitable for AEG stock guides where space is limited.
The battery's wiring has been shortened - it is only 2.5cm long, making it easier to place in limited space.

Lithium-ion-polymer(LiPo) packs are the successors to the well-known lithium-ion (LiIon) packs. The main advantage of LiPo batteries is undoubtedly their capacity-to-size ratio. They are very small in size while retaining a very high current capacity, which makes it possible to select a suitable pack for practically every AEG replica. They have no memory effect. They can be charged very frequently without being discharged first. Frequent charging is beneficial for this type of battery.

It is important to remember not to discharge a LiPo pack below 3V per cell and not to overcharge it above 4.2V per cell. Another advantage of LiPo packs is the low percentage self-discharge. When not in use, the pack loses about 3-5% of its energy per month. It is necessary to keep an eye on the pack, as during very long storage a discharge below the permissible minimum value ( 3V per cell ) and irreversible chemical reactions may occur, which may cause deterioration of the pack properties including its permanent damage, in extreme cases - ignition. An unused LiPo pack should have an average charge of approximately 70%.

When used correctly, the life of LiPo packs averages 500-700 cycles. An important aspect is the temperature at which LiPo packs can operate. Unlike other batteries, LiPo cells perform well at low temperatures; however, they should be charged at room temperature. To keep LiPo batteries in good condition, they should be balanced during charging using the service plug that most LiPo packs have (a good LiPo charger has a built-in balancer).

The battery has 2 modules of the same size.
Single module dimensions:
106x19.2x5.5mm

After use, detach the battery from the replica.